14-240/Tutorial-October28: Difference between revisions
(→Boris) |
|||
Line 50: | Line 50: | ||
'''Consider the following strategy only if you are working with concrete sets and vector spaces:''' |
'''Consider the following strategy only if you are working with concrete sets and vector spaces:''' |
||
If a problem requires us to extend a linearly independent |
If a problem requires us to extend a linearly independent set to a basis, then the easiest approach is to add vectors from the |
||
standard ordered basis. Here is an example: |
|||
Revision as of 13:14, 9 November 2014
|
Boris
Try to Avoid the Einstellung Effect
By this point in the course, we become good at solving systems of linear equations. However, we should not use this same
old problem-solving strategy over and over if a more efficient one exists. Consider the following problems:
Q1: Determine if is linearly independent in .
We can solve this linear equation to find the answer:
- where .
Yet there is a less time-consuming approach that relies on two observations:
- (1) The dimension of is so the size of a basis is also .
- (2) No linearly independent set can have more vectors than a generating set (by the Replacement Theorem).
Since a basis is a generating set and the size of is , then the Replacement Theorem tells us that cannot be linearly
independent. Hence, the problem can be solved without solving any linear equations.
Q2: Determine if the polynomials generate .
Once again, we can solve a linear equation but we do not have to. Observe:
- (1) The dimension is so the size of a basis is also .
- (2) No generating set can have fewer vectors than a basis (by a Corollary to the Replacement Theorem).
Since there are only polynomials, then the Corollary tells us that it cannot generate . Once again, we used a
more efficient strategy to solve a problem.
Extending a Linearly Independent Set to a Basis
Consider the following strategy only if you are working with concrete sets and vector spaces:
If a problem requires us to extend a linearly independent set to a basis, then the easiest approach is to add vectors from the
standard ordered basis. Here is an example:
Let be a linearly independent subset of . To extend to a basis of , add
vectors from . The only question is which vectors should we add?
We see that both vectors in have a as the third component so a safe choice is to add . Since has a
dimension of , then is a basis of .